Three Major Components of the Mobile mixing station

Mobile mixing station is a fixed type of concrete mixing plant developed on the basis of new mechanical equipment, there are traction and traction in two forms, but no matter what form of mobile mixing stations contain the following three components .

1. Stirring system

The mixing station of the mobile mixing station is forced by the double horizontal shaft, the mixing time is short, the discharge is quick, the mixing is uniform, the productivity is high, the dry hardness, the plasticity and the concrete with different compaction are well stirred and the quality is reliable;

Liner material, high quality wear-resistant cast iron, angle value through the finite element analysis and design, making the mixing efficiency to the highest, the longest life;

Unique shaft end bearing and sealing design, with the bearing support seal separation, a variety of shaft seal protection to make the bearing seal reliable, the host of the service life has been greatly improved.

2. Batching system

The mixing batching system is located at the rear end of the whole station, the upper part is the aggregate (sand and stone) storage hopper, the hopper can be divided into 2 or 4 cells, and set the plate to increase the storage capacity, Pneumatic in turn open the door operation, aggregate measurement for a variety of materials accumulated measurement. The bottom is equipped with a walking leg and a working leg. Cement, water, additives are weighing bucket, accurate measurement, computer centralized control, simple operation.

3. Control system

The control room of the mobile mixing station is at the bottom of the main chassis, and the automatic control system is installed in the mixing station. The control system is the same as the fixed mixing station. The control room is used as the front support point of the whole station. Stored in the bracket within the air, all of its control lines without demolition.