News

The electrical connection work of the forced mixer is a…

Check the lubrication of the lubrication points of each operating part of the concrete mixer. Insufficient lubrication, the floating seal ring in the shaft end seal is easily damaged. It causes leakage at the rail ends and a series of hazards caused by the stable-mixing soil mixer.

The construction conditions of the concrete mixing plant are rather harsh. Normally, the probability of anomalies in maintenance of concrete mixing plants is relatively high. As a result, the produced concrete is unqualified and the components of the concrete mixing plant are damaged. These will bring certain losses to the concrete mixing plant enterprises.

These problems may exist during operation of the multifunction blender. If you want to use it better, learn about it in advance. In order to avoid frequent failures or accidents in subsequent use, it is more troublesome to solve.

These devices can help the mixing chamber to store sand and gravel. Each part reflects its own characteristics. In order to ensure the smooth production, what parts need daily maintenance?

The batching control system of the concrete mixing plant is an indispensable part of the production line. A good control system can bring a lot of convenience. The following is a summary of the advantages of the control system.

The oil level in the crankcase of the air compressor should be kept above the low oil level marking line. The oil level and the quality of the lubricating oil should be checked every half a month or regularly.

After completing the installation of the large mixer, you need to debug it to understand whether there are any undiscovered problems. Let’s see how to enter sideways. The mixer is used for debugging. The following is a specific introduction, I hope to help everyone.

The control of the raw material of the forced mixer is directly related to the quality of the concrete. If you want to strictly control the entry of raw materials, you must start at the source. Before starting the forced concrete mixer.

The concrete mixing plant is mainly divided into four parts: gravel feeding, powder feeding, water and admixture feeding, transmission mixing and storage. The whole body of the equipment is cast with integral steel structure. High-quality H-shaped steel is not only beautiful in appearance.

The influencing factors are mainly the poor feeding of the powder tank and the damage of the screw conveyor. The poor performance of the powder feed is characterized by powder arching.

When choosing a small concrete mixer, we need to choose from the following four aspects.